Mixed speakers series wiring | Warehouse Guitar Speakers
FREE SHIPPING TO 48 CONTINGUOUS UNITED STATES ON ORDERS $99 AND UP

Mixed speakers series wiring

3 posts / 0 new
Last post  |
zebrawolfgang
04/15/2018 9:08am

Hello everyone, I have a question about mixed speaker wiring...I've searched the forum but I haven't found an exhaustive answer :)

I'm quite experienced with WGS speakers, with Vet30 Green Beret and Reapers.

Now I have 2 2x12 cabs, one with two WGS 12L and one with two WGS black hawk HP.
Each speaker is 8ohm wired in series with the other.

Now I would like to put a 12L in series with the Black Hawk HP in each cab.

I would like to know if the different wattage of the speakers could cause any interaction with the other (I now that in parallel wiring the speakers will influence each other), in a series wiring will happen too or each speaker sounds with its original voice?

What do you think?

Thank you for your answers :)

Daniel St Peters
08/23/2018 9:16am

Wattage doesn't matter at all when it comes to mixing speakers.

VAUGHN SKOW
08/27/2018 3:59pm

Yes, it will be just fine ... the only slightly difficult part will be that the BH HP will have standard speaker lig connectors ... and the 12L will have the heavy binding posts ... but I'm sure you can handle that! When your done, each cab will be good for about 200-watts RMS.